alcoa tn to murfreesboro tn
Protection for sheet metal edges, pipe ends and PC boards Edge liners are used to cover the sharp edges of cut sheet metal. In some cases, they can be used as spacers to protect the sheet metal face or installed as protection around a large or irregularly shaped hole. If seams are wider than 1/16" you may want to bridge seams with Dicor Fleece Tape 511FT. Additionally, if on the roof edge, the membrane will be going over a sharp edge, you should either bevel the edge of the substrate with a sander or place the Dicor Fleece Tape 511FT over the edge to protect the membrane from the edge. 5.
Pull up on the free end of the sheet and, using a mallet, tap the bend area tightly against the block. To sharpen the corner further, hold a scrap block against the metal and tap on it. For a long bend in sheet metal—say, to customize a length of flashing—replicate a metal brake (the folding tool the pros use): clamp the sheet with a full.